Short of a fresh Windows install again and ONLY installing engine and fusion I'm at a dead end. Used CCleaner to clean registry after every uninstall.Tried just RGB fusion which I had on my old rig (didn't use engine).Uninstalled all other RGB software - Asus Aura, Lian-Li L Connect, iCue, NZXT Cam, uninstalled engine and fusion and reinstalled both with no other RGB software installed.
Used DDU to remove latest NVidia drivers, uninstalled Engine and Fusion, installed drivers listed on Gigabyte site, reinstalled engine and fusion.īelow tried with recommended drivers left installed:. I think on two occasions it detected 3 of my 4 DIMMs, but never the graphics card and the DIMMs is pot luck on when it detects them. When I load up fusion it takes an age to load and when it does I am just presented with a blank motherboard picture. I had the 3080 installed on my old rig and it detected it okay with just fusion installed, but this fresh build simply won't have it. I know this has been asked a million times and I ran through searches everywhere and tried various things seen in other threads, but RGB fusion simply won't detected the 3080 on my new rig. Rule #5 - Please direct all RMA questions or comments to our customer service at 1 (626) 854-9338 op. Rule #4 - Begging, trading, or selling will not be tolerated. Brigading, witch-hunting, vote manipulation, flamebaiting, clickbaiting or intentional rudeness will not be allowed. Rule #2 - Remember the human, please follow Reddiquette. 
Rule #1 - All content must be related to GIGABYTE.
While you're at it, please take a minute to go over our rules: We love to hear your feedback and experiences with your products. Welcome to the official GIGABYTE subreddit!įeel free to discuss the latest gaming hardware, PC gaming, and show off your GIGABYTE builds.
0 kommentar(er)
